MC-1200 Steel Tower with structural analysis
Hot dip galvanized telescopic masts, consisting of three sections with 3m length, plus top unit with 1m length and socket, plus base piece. Width of edge on lower segment 40cm, extended length approx. 12m.
The 45° cross beams of the masts are made of solid material (not tubes). Additionally one side has horizontal cross beams of the same diameter. With this you can climb up the mast in principle, although we do strongly warn about climbing a telescopic tower.
The masts are suitable for a 'standard' HF beam or multiple VHF Yagis. We do not supply a static calculation with these masts. In Germany the regulations usually require a build permit for masts above 10m height. This permit normally requires a static calculation.
The masts do have a simple hinge at the bottom for easier installation, see picture. Included in shipment is an ALKO winch with 500kg traction force, incl. steel rope. Also included is an universal base plate which can be bolted to the ground or used in a concrete basement (see pictures).
The top unit offers enough space for a rotator and contains two friction bearings suitable for 48.5 mm tubes. Included in the shipment is a ball bearing at the top position. A short and simple steel tube is included with each mast. But this is a simple tube without any strength specification, suitable only for lighter antennas. In case of doubt please replace this with a higher specified tube. The kit required for a concrete basement is not included and must be ordered separately (see below).
We do offer a structural analysis paper for the MC-1200 tower. This analysis is based on the assumptiosn as shown below. The price of the analysis is intended as a contribution to the total cost of that paperwork. This analysis is 238 pages long and includes the construction drawings and plans for a concrete foundation.
Assumed data for structural analysis:
- Wind Load Zone 1 (WZ1), alternatively WZ2
- max. allowed foundation pressure 150 KN/qm
- Icing: none (Data for ice zones 1 and 2 are available.).
Under different circumstances, for example in the mountains or close to the sea other assumptions for the structural analysis must be allowed for!
|Antenna Surface [m²]||at antenna weight [kg]|
|WZ1||WZ2||WZ1 & 2|
|With lower guying||0.8||0.5||50|
|With middle guying||1.0||0.7||50|
|With top guying||5.0||4.0||100|
WZ1 is valid for wind speeds < 22,5 m/s, WZ2 for < 25,0 m/s.
In coastal areas, higher wind speeds may apply!
|Sections||3 x 4||m|
|Width of lower edge||40||cm|
Tube size on corners
|42 x 3.2||mm|
|Cross bar on lower section||Solid, 10||mm|
|Cross bars on middle and upper section||Solid, 8||mm|
|Weight top unit||14||kg|
|Foundation size||1.2 x 1.2 x 1.7||m|
|38360.4||MC-1200 Telescopic steel tower with winch||2630.00 €||Buy now||New||In stock, shipped in 1 or two days. ⓘ|
|38360.STA||Structural Analysis (238 pages)||180.00 €||Buy now||New||In stock, shipped in 1 or two days. ⓘ|
|38351||Option for Concrete Base MC-1200||120.00 €||Buy now||In stock, shipped in 1 or two days. ⓘ|
|Info freight charges|
Alko Hand winch
Made in Germany, massive construction, without rope. Note: the a.m. masts do include such a winch, incl. steel rope.
|38380.500||Alko Hand winch 500Kg||179.00 €||Buy now||In stock, shipped in 1 or two days. ⓘ|
|Info freight charges|